Assembly

3 Install the pulley

 

HARDWARE

 

 

 

 

H3

 

 

 

 

 

H2

 

 

 

 

Bolt

 

Bolt 1/4"-20x1-3/4"

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

H4

H6

Lock Nut 1/4"-20

Nut 3/8"

H7

Lock Washer 3/8"

3.1Lay the belt beside the rail, as shown. Grasp the end with the hooked trolley connector and pass approximately 12" (30 cm) of belt through the window.

Keep the ribbed side toward the rail, and allow it to hang.

3.2Remove the tape from the pulley. The center should be greased, if not, re- grease the center of the pulley.

3.3Insert the pulley into the window of the front rail.

3.4Insert the bolt (H3) into the rail and pulley. Tighten securely with the lock washer (H7) and nut (H6).

3.5Rotate the pulley to be sure it spins freely.

3.6Insert the bolt (H2) into the hole shown and fasten with the lock nut (H4).

H2

Screwdriver

Rail

H3

Pulley

H7

H6

Trolley

H4Connector

8