Chariot Carriers Chariot Baby Seat manual Securing on the Cabriolet, CX2 and Cougar2 models

2.2.2 Securing on the Cabriolet, CX2 and Cougar2 models

First connect the fastex buckles on the underside of the baby seat with their counterparts on the lap belt ends.

For side-fitting, use the belt ends of the lap belt of the side in question.

For fitting in the centre, use the central belt ends of both lap belts.

Experience has shown that it helps if an overall belt length adjustment of more or less 15 to 16 cm is made (measured from the point of attachment to the baby seat to the point of attachment to the trailer seat).

Illustration A

Now lay both straps that are at the front end of the baby seat around the fitted telescopic tube, thread the ends through the fasteners, as in the top right hand picture, and pull the straps through, so that the front edge of the seat is at a distance of about 10 cm from the telescopic tube.

Correct positioning of the baby seat.

The next step is to connect the safety belts in the trailer with the baby seat:

Insert the trailer seat crotch	Then insert the fastnex insert
harness from the rear through	through the elastic loop at the
the slot in the baby seat in front	end of the flap for the padding.
of the flap for the padding.

For side fitting, the crotch harness of the seat part of the relevant side can be used. For centre-fitting, there is an additional crotch harness in the centre of the trailer seat.

Please note:

The first production model of the Cabriolet incorporated the belt system described on pages 6 (bottom) and 7 (top).

If your Cabriolet has this belt system, read the section about connecting the safety belts with the baby seat on

page 6 (bottom) and page 7 (top), and then come back to the text which follows in this section.

46