Chariot Carriers Chariot Baby Seat Please note Make sure you check all belt buckles are tight

Insert the shoulder harness that is on the appropriate side of the baby seat through the lower or upper slot of the baby seat, depending on the size of the child.

Working towards the rear, insert the shoulder harness through the ring of the lap belt and the corresponding slot on the other side of the baby seat.

Connect the insert of the fastex buckle with its unit on the backrest of the trailer seat. (The fastex buckle should be in its lowest position.)

For centre-fitting, the right hand shoulder harness in the direction of travel is threaded through the baby seat as described above, and the insert of the fastener is connected with the unit of the left hand shoulder harness looking in direction of travel.

Illustration A

Now lay both the straps that are at the top end of the baby seat around the top crossbar inside the trailer.

Thread the strap through as illustrated…

…and pull the strap tight.

Finally pull all fastening straps tight. (If necessary the trailer body will need to be opened out again beforehand.)

If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the other four straps tight. If you want an adjustment of greater incline, the procedure is the same but reversed.

Please note: Make sure you check all belt buckles are tight.

Fitted baby seat ready to use in the centre and side position:

Please note:

Never transport your children without the safety belts being properly and fully adjusted, otherwise your child could be seriously or even fatally injured in the event of an accident!

45