Finally pull all fastening straps tight. (If necessary the trailer body will need to be opened out again beforehand.)
If you want to adjust the seat to a flatter position, loosen both of the top fastening straps and pull the other four straps tight. If you want an adjustment of greater incline, the procedure is the same but reversed.
Please note: Make sure you check all belt buckles are tight.
Fitted baby seat ready to use in the centre and side position:
Please note:
Never transport your children without the safety belts being properly and fully adjusted, otherwise your child could be seriously or even fatally injured in the event of an accident!
2.2.3 Securing on the Corsaire XL and Captain XL models
2.2.3.1 Preliminary steps
First guide the bungee cord supplied through the lateral flaps that are at the bottom towards the front and pull it very tight.
When viewed from the inside of the transpor- ter, the bungee cord and flaps should be positioned in front
of the vertical frame tubes.
Place the baby seat in the trailer as shown in the above picture.
2.2.3.2 Lateral positioning
Illustration A
Start with the strap that points outwards at the front of the baby seat.
Thread it down in front of the telescopic tube.
Thread the strap through the flap at the bottom – the bungee cord is pulled through this as well. Now once again, in front of the teles- copic tube, pull it upwards again.
Thread the end of the strap as shown in the above illustration through the fastener in the baby seat and gently pull the strap tight.
48
