Christie Digital Systems DHD800 Terminals and Connectors,
USB Connector Series B, LAN port

Part Names and Functions

Terminals and Connectors

USB CONNECTOR (Series B)

USB connector is used to service the projector.

5 BNC INPUT JACKS

Connect the component or composite video output signal from video equipment to VIDEO/Y, Pb/Cb, and Pr/Cr jacks or connect the computer output signal (5 BNC Type [Green, Blue, Red, Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V jacks. (pp.20–21)

D-sub 15-PIN INPUT TERMINAL

Connect computer output (Analog D-sub 15-pin type) to this terminal. (pp.20-21)

MONITOR OUT TERMINAL

This terminal can be used to output the incoming analog RGB, component, or composite video out signals from INPUT 1-2 terminal to the other monitor. (pp.20-21)

DVI INPUT TERMINAL

Connect computer output (Digital/DVI-D type) to this terminal. (p.20)

HDTV (HDCP Compatible) signal can be also connected. (p.21)

HDMI

Connect the HDMI output signal from video equipment to this terminal. (p.21)



S-VIDEO INPUT JACK

Connect the S-VIDEO output signal from video equipment to this jack. (p.21)

SERIAL PORT IN TERMINAL

If you control the projector through RS-232C from a computer, you must connect a cable (not supplied) from your computer to this terminal.

SERIAL PORT OUT TERMINAL

This terminal outputs signal from SERIAL PORT IN. More than two projectors can be controlled through RS-232C from one computer by connecting SERIAL PORT IN of another projector to this terminal.

LAN port

Connecting the Ethernet cable. See the owner's manual of “Network Set-up and Operation” for details.

R/C JACK

When using the wired remote control, connect the wired remote control to this jack with a remote control cable (not supplied).

DHD800 User Manual	11
020-000244-01 Rev.1 (08-2010)