Christie Digital Systems DHD800 Optional Color Wheel Installation, Maintenance and Care

Maintenance and Care

Optional Color Wheel Installation

The projector comes with the high brightness color wheels installed. Additional rich color reproduction color wheels are supplied. To replace the color wheels, refer to the following steps.

1Turn off the projector, press the Main On/Off Switch to Off and unplug the AC power cord from the AC outlet. Let the projector cool for at least 45 minutes.

2Loosen a screw on the Lamp Cover. Slide and open the Lamp Cover. (See the right figure.)

3Loosen three screws and pull out the color wheel to be replaced by grasping handle.

4Replace the color wheel with a new one and tighten three screws. Make sure the color wheels are set properly.

5Put the Lamp Cover back and tighten a screw.

Note:

•Wait until the lamp house and the color wheel cool off.

•Make sure to install the same type of two color wheels at the same time. When different types of color wheels are installed, ‘Non-matching color wheels!‘ message appears on the screen.

SCREW

LAMP

COVER

COLOR WHEELS

SCREWS

Allow the projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of the projector can become very hot.

70	DHD800 User Manual
	020-000244-01 Rev.1 (08-2010)