Christie Digital Systems DHD800 user manual Filter control, Fan control, Remote control, RC sensor

Setting

Filter control

This function does not work in the default state. When a filter cartridge (supplied) has been installed in the projector, it works as follows:

You can replace the filter with this function. Press the SELECT button at Filter control to display a confirmation box. To replace, press the SELECT button at “YES” and the electrically operated filter starts to scroll.

You can also replace the filter by using the remote control (p.31).

Fan control

Choose the running speed of cooling fans from the following options.

Normal	Normal speed.
Max	Faster than the normal speed.

Note:

When a filter cartridge (supplied) has been installed in the projector;

•Filter replacement icon and “Please wait...” message appear on the screen when the filter is being scrolled.

•The filter cannot be rewound.

•When the filter is replaced, the total accumulated time of the filter use is automatically set to 0.

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should be set on both the projector and the remote control. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector;

Select a remote control code in this Setting Menu.

To change the code for the remote control;

Check the Reset Switch to "Use position" in the compartment lid on the back of the remote control.

And then while holding down the MENU button, press and release the IMAGE ADJ. button the number of corresponding times you would like to set the number of the remote control code for the projector. (See page 16)

To reset the code for the remote control;

Slide the Reset Switch to "Reset position" in the compartment lid on back of the remote control.

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Receivers and Operating Range” on page 15 for details.

All . . . . . . . . . . .Activate all of the front, top and back receivers. Front & Top . . . .Activate the front and top receivers.

Top & Back . . . .Activate the top and back receivers. Front & Back . . .Activate the front and back receivers. Front . . . . . . . . .Activate only the front receiver.

Top . . . . . . . . . .Activate only the top receiver. Back . . . . . . . . .Activate only the back receiver.

Remote control

When pressing the SELECT button at Remote control, the Remote control code menu appears.

56	DHD800 User Manual
	020-000244-01 Rev.1 (08-2010)