Christie Digital Systems DHD800 Basic Operation, Turning On the Projector, Enter a PIN code

Basic Operation

Turning On the Projector

1Complete peripheral connections (with a computer, VCR, etc.) before turning on the projector.

2Connect the projector’s AC power cord into an AC outlet and turn on the MAIN ON/OFF Switch. The LAMP indicator lights red and the POWER indicator lights green.

3Press the ON/STAND-BY button on the side control or on the remote control. The LAMP indicator dims red and the cooling fans start to operate. The preparation display appears on the screen and the countdown starts.

After the countdown, the input source that was

4 selected the last time and the Lamp status icon (see page 67) appear on the screen.

If the projector is locked with a PIN code, PIN code Input Dialog Box will appear. Enter the PIN code as instructed below.

Enter a PIN code

Use the Point 54 buttons on the side control or on the remote control to enter a number. Press the Point  button to fix the number and move the red frame pointer to the next box. The number changes to “3.” Repeat this step to complete entering a four-digit number. After entering the four-digit number, move the pointer to “Set.” Press the SELECT button so that you can start to operate the projector.

If you fixed an incorrect number, use the Point  button to move the pointer to the number you want to correct, and then enter the correct number.

If you entered an incorrect PIN code, “PIN code” and the number (3333) will turn red for a moment. Enter the correct PIN code all over again.

What is PIN code?

PIN (Personal Identification Number) code is a security code that allows the person who knows it to operate the projector. Setting a PIN code prevents unauthorized use of the projector.

A PIN code consists of a four-digit number. Refer to the PIN code lock function in the Setting Menu on pages 58- 59 for locking operation of the projector with your PIN code.

CAUTION ON HANDLING PIN CODE

If you forget your PIN code, the projector can no longer be started. Take special care in setting a new PIN code; write down the number in a column on page 88 of this manual and keep it on hand. Should the PIN code be missing or forgotten, consult your dealer or service center.

16

The preparation display will disappear after 20 seconds.

Selected Input Source and Lamp control

Lamp status

See page 67 for the Lamp mode status

Note:

•The Lamp replacement icon may appear on the screen depending on the usage state of the projector.

PIN code Input Dialog Box

After the OK icon disappears, you can operate the projector.

Note:

•When the Logo select function is set to “Off,” the logo will not be shown on the screen (p.54).

•When the “Countdown off” or “Off” is selected in the Display function, the countdown will not be shown on the screen (p.49).

•During the countdown period, all operations except for Zoom, Focus, and Lens-shift functions are invalid. If the projector has been locked with a PIN code, however, Zoom, Focus, and Lens-shift functions are also invalid.

•If you press the ON/STAND-BY button on the side control or the remote control during the countdown period, you can skip the countdown and go to the normal operations.

•If the PIN code number is not entered within three minutes after the PIN code dialog box appeared, the projector will be turned off automatically.

•The “1234” is set as the initial PIN code at the factory.

24	DHD800 User Manual
	020-000244-01 Rev.1 (08-2010)