Setting
HDMI setup | HDMI setup |
|
Select Normal or Enhanced according to the output signal of video equipment. Press the Point buttons to switch between each option.
Normal . . . . When the output of video equipment is set to “STANDARD.”
Enhanced . . When the output of video equipment is set to “ENHANCED.”
The names for the output setting of video equipment vary from equipment to equipment. For details, refer to the owner’s manual of video equipment.
When the black parts of the image are destroyed or stand out, please switch to "Normal" or "Enhanced", and then switch the output type of the HDMI video output equipment.
Press the Point buttons to select Normal or Enhanced according to the output signal of video equipment.
Logo | Logo |
This function allows you to customize the screen logo with Logo select, Capture, and Logo PIN code lock functions.
Logo select
This function decides on the
Off . . . . Show the countdown display only. Default . Show the
User . . . Show the image you captured.
Capture
This function enables you to capture an image being projected to use it for a
Select Capture and press the SELECT button.
A confirmation box appears and select [Yes] to capture the projected image.
After capturing the projected image, go to the Logo select function and set it to “User”.Then the captured image will be displayed the next time you turn on the projector.
To cancel the Capture function, select [No].
Note:
•Before capturing an image, select “Standard” in the Image Select Menu to capture a proper image. (pp.39, 43)
•A signal from a computer can be captured up to 1920 x 1080 dots.
•Certain signals may not be captured properly.
•When capturing the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone correction.
•When starting to capture a new image, the previously stored image is cleared even if you cancel the capturing.
•Once you exit the Logo Menu after setting the Logo lock to "On," you are required to enter the PIN code every attempting to change the Logo setting.
•“User” cannot be selected when the image is not captured.
Set the red frame pointer to the item and press the SELECT button.
Note:
•When “On” is selected in the Logo PIN code lock function, Logo select and Capture functions cannot be selected.
Capture
Set the pointer (red arrow) to the item and press the SELECT button.
Select [Yes] to capture the projected image.
Select [Yes] to stop capturing.
54 | DHD800 User Manual | |
|
