Christie Digital Systems DHD800 Setting, Picture in Picture, To store the adjusted data

Setting

Picture in Picture

Status (Stored /Free/

Selected Mode

Adj.) of the selected

mode.

Picture in Picture

This function is used to project two videos simultaneously by placing a separate small sub screen within or next to the main

screen. Use the Point  buttons to adjust

the setting value.

Use the Point 54 buttons to move the red frame pointer to Picture in Picture and then press the SELECT button to display a dialog box. You can also display the dialog box by pressing and holding the PIP button on the remote control for more than 3 seconds.

Use the Point  buttons to adjust the setting value.

Picture in Picture . . .Show the selected mode (Off/User1-5) and its status (Stored /Free/Adj.). 'User1' and 'User2' have stored default values. See page 30 for details.

Mode . . . . . . P in P: Provide the images of Main picture and Sub picture at the ratio of 16:9.

P by P: Provide the images of Main picture and Sub picture at the ratio of 4:3.

Main picture/		Active
Sub picture . . .
Input:	Select an input from Input 1-4.	frame
		(White)
Source: Select an input source. The display varies
	depending on the selected input.
Size:	Select the display size. Main picture can
	be changed between 10 and 100%, and	Center line
	Sub picture can be changed between 10 to
		display
	50% in increments of 10%. When P by P is
	selected in Mode, the projection size is fixed
	to 50%.	To store the adjusted data.
Position: Press the SELECT button at Position and
	the display position setting screen appears.	This mode
	Use the Point 544 buttons to adjust the
		has stored
	display position of active frame indicated
		data.
	in white. The frame will disappear after 10
	seconds or when the SELECT button is	Vacant
	pressed.
Frame Lock . . . Set the Frame Lock to Main picture or Sub
	picture.
Reset . . . . . . . . Press the SELECT button at Reset to display
	a confirmation box. To reset, press the
	SELECT button at [Yes].	Close this dialog box.
Mode free . . . . Delete the data stored in the Mode and
	return to the ‘Free‘ state. Use the Point 	Confirmation box appears
	 buttons to select Mode free and press
	the SELECT button to show the 'Where	and then select [Yes].
	to free?' dialog box. Move the red arrow	Note:
	pointer to one of the mode (Mode 1 - 5)
		• The Picture in Picture function is not available depending
	which you want to delete and press the
	SELECT button. Then the Confirmation box	on the input signals and the selected input terminals. Refer
	appears. To delete, select [Yes].	to ‘List of Picture in Picture‘ for details. (p.84)
Store . . . . . . . . Store the adjusted data in the User 1–5.		• When the input signal(s) is/are incompatible, X mark will
	Use the Point  buttons to select Store	be displayed on the Main/Sub picture.
	and press the SELECT button to show the	• While the Main and Sub pictures are being displayed,
	‘Where to store?‘ dialog box. Move the red	System, Image select, Image adj., Screen menus (except
	arrow pointer to one of the mode (Mode 1	for ‘Keystone’, ‘Ceiling’ and ‘Rear’), and DynamicBlack are
	- 5) in which you want to store and press the	inoperative.
	SELECT button. Then the Confirmation box	• ‘Progressive’ and ‘Noise reduction’ functions are fixed to

appears. To store adjusted data, select [Yes].	‘Off’ during the Picture in Picture operation. Therefore, the
Quit . . . . . . . . . Exit the Picture in Picture menu.
	image may become grainy depending on the input signal.
DHD800 User Manual	51
020-000244-01 Rev.1 (08-2010)