Christie Digital Systems DHD800 Connecting the AC Power Cord, AC Outlet side, Projector side

Installation

Connecting the AC Power Cord

This projector uses nominal input voltages of 100-240 V AC.	Holes
It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce the risk of
electrical shock, do not plug into any other type of power
system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning on the projector.
2 types of fixing brackets are provided to prevent the AC power
cord from coming loose. Confirm your AC plug type with the
chart below and use the proper type of fixing bracket.
Follow these steps to attach the fixing bracket and connect the
AC power cord to the projector.

Fixing bracket

1Fit a fixing bracket in each hole.

2Connect the AC power cord to the projector.

3Turn the fixing bracket to lock the AC power cord in place. (See the right figure.)

Note:

•Unplug the AC power cord or turn off the MAIN ON/ OFF Switch when the projector is not in use. When the projector is in stand-by mode, it consumes a little electric power.

CAUTION

The AC outlet must be near this equipment and must be easily accessible.

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector.

Confirm the AC plug type with the chart below and proper AC power cord must be used.

If the supplied AC power cord does not match your AC outlet, contact your sales dealer.

AC Outlet side	Projector side	Fixing Bracket
For the U.S.A. and Canada
Ground
	To POWER CORD	Part No. 610 342 7744
To the AC Outlet.	CONNECTOR on your	(Narrow)
	projector.
(120 V AC)

For Continental Europe

To the AC Outlet.	To POWER CORD	Part No. 610 342 7751
	CONNECTOR on your	(Wide)
(200–240 V AC)	projector.
DHD800 User Manual		23
020-000244-01 Rev.1 (08-2010)