Picture Image
COLOR SELECTION MODE (continued)
COLOR M.
Return to the COLOR MANAGEMENT POINTER. (If you press the MENU button on the side control or the remote control, it returns to the COLOR MANAGEMENT POINTER and you will need to reselect and readjust the color.)
MENU
Return to the IMAGE ADJUST Menu. Any settings that have been changed will not be stored. To store the changed settings, be sure to select “LIST” and go to the
COLOR MANAGEMENT LIST.
4In the COLOR MANAGEMENT LIST, the adjusted color data are checkmarked. You can decide whether or not to apply the adjusted color data in the list to the projected image (see below).
COLOR SELECTION MODE
Level and phase | Gamma |
adjustment palette. | adjustment palette. |
LIST |
| COLOR M. |
| MENU |
LIST MODE
Clear the check mark if you do not want to apply the adjusted color data; select the check mark and then press the SELECT button. The check mark disappears.
COLOR PALETTE
Return to the COLOR SELECTION mode so that you can readjust the setting for the color in that line. (This option is not available if the check mark is cleared.)
DEL
Select the DEL box if you want to delete the adjusted data. Press the SELECT button and a confirmation box appears and then select [Yes].
ALL DEL
Delete all the data in the list. Press the SELECT button and a confirmation box appears and then select [Yes].
MENU
The same function as stated above.
COLOR M.
The same function as stated above.
Auto picture control
LIST MODE
COLOR PALETTE
DEL
ALL DEL |
| MENU |
| COLOR M. |
Use the Point buttons to select the desired Auto picture control position (Off, L1 or L2).
Off . . . . Auto picture control OFF position.
L1 . . . . . Auto picture control LEVEL 1 position.
L2 . . . . . Auto picture control LEVEL 2 position.
BrilliantColor
Set to ‘On‘ to achieve a wider range of color reproduction and increase the brightness of the halftone. Use the Point buttons to select from (Off/On).
Color temp.
Use the Point buttons to select the desired Color temp. level (XLow, Low, Mid, or High).
Note:
•Color temp. will be displayed in grayout when ‘Dynamic‘ is selected in the Image level selection (pp.39, 43).
DHD800 User Manual | 47 | |
|
