Cino FM400 manual Data Formatter Setting, Formatter Control

Mount	Manual
FuzzyScanFixed	Programming
	Scan

Condensed DataWizard

♦ Data Formatter Setting ♦

PROGRAM					F_DEFAULT
Family Code Selection	P.C	Parameter Selection		Option Code	2nd Option Code
Formatter Control	SS	Disable ￿		FIN
	MS	Select one bar code symbology		(2 digits)	automatic termination
	MS	Select all bar code symbologies	00		automatic termination
1st Insertion	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[1-3 characters], [FIN]
		2-digits identified position; max. 3 insertion characters		position
2nd Insertion	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[1-3 characters], [FIN]
		2-digits identified position; max. 3 insertion characters		position
3rd Insertion	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[1-3 characters], [FIN]
		2-digits identified position; max. 3 insertion characters		position
4th Insertion	SS	Disable ￿		FIN
	DS	Enable		(2 digits)	[1-3 characters], [FIN]
		2-digits identified position; max. 3 insertion characters		position

￿The Data Formatter is used to edit the scanned raw data prior to transmitting the data to the host computers or terminals. It allows you to select desired bar code symbologies for formatter control, and provides Multiple Position Insertion and Multiple Character Insertion (max three characters) in the identified position.

￿While the Data Formatter is enabled, it arranges only scanned data without Preamble, Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix. All of the above programmable parameters perform the same function depending on your setting.

￿Regarding the “Bar Code Selection” and “Position Calculation” of data formatter, please refer to page 49 for details.

￿Please note that all “Character” input should be referred to the ASCII/HEX Table listed in Appendix to find matched HEX value.

50