Chapter14 Routing
BGP Address Family Configuration
14-56
Cisco 12000/10720 v3.2 Router Manager User Guide
OL-6690-01
Loopback No—This is used to configure Router's Loopback Interface Number.
This is valid only if Update-Source is set to YES.
Note This attribute is configurable only for the ipv4 unicast and ipv4 vrf address
families.
Action
Add Neighbor Entry—Clicking on the “Add Neighbor Entry” button, adds the
neighbor entry for the BGP Address Family.
Remove Neighbor Entry—Clicking on the “Remove Neighbor Entry” button,
removes the neighbor entry for the BGP Address Family.
Viewing the AF-Redistribute Tab on the BGP Address-Family Configuration Window
The AF-Redistribute tab displays the information about the redistribute protocols
configured for a BGP address family. The user can add or remove the redistribute
entries for an address family. To view the AF-Redistribute tab on the BGP
Address Family Configuration window for a chassis, proceed as follows:
Step1 Open the BGP Address-Family Configuration window. See “Viewing the
AF-General Tab on the BGP Address-Family Configuration Window” section on
page 14-38 for further details.
Step2 Click on the AF-Redistribute tab.