A P P E N D I X C

Configuring the Switch with the CLI Setup

Program

This appendix provides a command-line interface (CLI) setup procedure for a standalone switch. To set up the switch by using Express Setup, see the Cisco CGS 2520 Getting Started Guide. Before connecting the switch to a power source, review the safety warnings in the “Switch Installation” section on page 2-1and the “Power Supply Module Installation” section on page 3-2.

Accessing the CLI Through the Console Port

You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access the CLI:

RJ-45 Console Port, page C-1

USB Console Port, page C-3

RJ-45 Console Port

Step 1 Connect the RJ-45-to-DB-9 adapter cable to the 9-pin serial port on the PC. Connect the other end of the cable to the switch console port.

Step 2 Start the terminal-emulation program on the PC or the terminal. The program, frequently a PC application such as HyperTerminal or ProcommPlus, makes communication between the switch and your PC or terminal possible.

Cisco CGS 2520 Hardware Installation Guide

 

OL-31444-01

C-1

 

Page 83
Image 83
Cisco Systems CGS 2520 manual Accessing the CLI Through the Console Port, RJ-45 Console Port