Chapter 3 Power Supply Installation

Power Supply Module Installation

Figure 3-12 Crimping the Spade Terminal Lug

207427

Step 6 Loosen the terminal screw, and slide the terminal under the screw and washer (see Figure 3-14).

Note Use the appropriate terminal screws, depending on whether you are installing a high-voltage (AC or DC) or a low-voltage (DC) power supply.

Step 7 AC power connection

Connect the line wire into the terminal screw labeled L and the neutral wire into the terminal screw labeled N.

Make sure that you cannot see any wire lead. Only wire with insulation should extend from the terminal screw.

Figure 3-13 Connecting the Wires to the High-Voltage AC Power (PSU1)

Cisco CGSS 25520

207429

DC power connection. Connect the positive wire into the terminal screw labeled +, and the negative wire into the terminal screw labeled . Make sure that you cannot see any wire lead. Only wire with insulation should extend from the terminal screw.

 

Cisco CGS 2520 Hardware Installation Guide

3-10

OL-31444-01

Page 60
Image 60
Cisco Systems CGS 2520 manual Crimping the Spade Terminal Lug