Cisco Systems CGS 2520 manual Installing the Switch, Mounting into a Rack, Mounting Brackets

Chapter 2 Switch Installation

Installing the Switch

Installing the Switch

The following installation information is covered in this section:

•Mounting into a Rack, page 2-4

•Wall-Mounting, page 2-16

Note After the switch is mounted onto the rack, connect the power source to the switch. For more information, see the “Power Supply Installation” chapter.

Mounting into a Rack

The following mounting procedures are explained in this section:

•Mounting Brackets, page 2-4

•Attaching Brackets for 19-Inch Racks, page 2-5

•Attaching Brackets for 19-Inch Racks (IP-30 Compliance), page 2-7

•Attaching Brackets for 23-Inch Racks, page 2-12

•Attaching Brackets for ETSI Racks, page 2-13

•Mounting the Switch into a Rack, page 2-15

Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to ensure that the system remains stable. The following guidelines are provided to ensure your safety:

•This unit should be mounted at the bottom of the rack if it the only rack in the rack

•When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack

•If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack. Statement 1008

Mounting Brackets

Figure 2-1shows the 19-inch rack mounting brackets.

Figure 2-1 19-inch Mounting Brackets

Cisco CGS 2520 Hardware Installation Guide

2-4 OL-31444-01