Cisco Systems D200 manual DLP-D241 Clear an MS-SPRing Manual Ring Switch, 19-45, Click Cancel

Chapter 19 DLPs D200 to D299

DLP- D241 Clear an MS-SPRing Manual Ring Switch

Step 1 From node or network view, click the Circuits > Rolls tabs.

Step 2 Click the rolled circuit that you want to cancel.

Step 3 Click Cancel.

Step 4 Return to your originating procedure (NTP).

DLP-D241 Clear an MS-SPRing Manual Ring Switch

Purpose	This task clears a Manual ring switch.
Tools/Equipment	None
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 From the View menu, choose Go to Network View.

Step 2 Click the Provisioning > MS-SPRing tabs.

Step 3 Choose the MS-SPRing that the Manual ring switch that you want to clear and click Edit.

Tip To move an icon to a new location, for example, to see MS-SPRing channel (port) information more clearly, click an icon on the Edit MS-SPRing network graphic and while pressing Ctrl, drag the icon to a new location.

Step 4 Right-click the MS-SPRing node channel (port) where the Manual ring switch was applied and choose Set West Protection Operation or Set East Protection Operation, as applicable.

Step 5 In the dialog box, choose CLEAR from the drop-down list. Click OK.

Step 6 Click Yes in the Confirm MS-SPRing Operation dialog box. The letter “M” is removed from the channel (port) and the span turns green.

Step 7 From the File menu, choose Close.

Step 8 Return to your originating procedure (NTP).

	Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007		19-45