Cisco Systems D200 DLP-D227 Disable Alarm Filtering, DLP-D229 View Circuits on a Span, 19-26

Chapter 19 DLPs D200 to D299

DLP- D227 Disable Alarm Filtering

DLP-D227 Disable Alarm Filtering

Purpose

Tools/Equipment

Prerequisite Procedures

Required/As Needed Onsite/Remote

Security Level

This task turns off specialized alarm filtering in all network nodes so that all severities are reported in CTC.

None

DLP-D225 Enable Alarm Filtering, page 19-25

DLP-D60 Log into CTC, page 17-49

As needed

Onsite or remote

Retrieve or higher

Step 1 At node, network, or card view, click the Alarms tab.

Step 2 Click the Filter tool at the lower-right side of the bottom toolbar.

Alarm filtering is enabled if the tool is indented and disabled if the tool is raised (not selected).

Step 3 If you want alarm filtering disabled when you view conditions, click the Conditions tab and click the Filter tool.

Step 4 If you want alarm filtering disabled when you view alarm history, click the History tab and click the Filter tool.

Step 5 Return to your originating procedure (NTP).

DLP-D229 View Circuits on a Span

Purpose	This task allows you to view circuits on an ONS 15454 SDH span.
Tools/Equipment	None
Prerequisite Procedures	Circuits must be created on the span. See Chapter 6, “Create Circuits and
	Low-Order Tunnels.”
	DLP-D60 Log into CTC, page 17-49
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Retrieve or higher

Step 1 From the View menu at node view, choose Go to Network View. If you are already in network view, continue with Step 2.

Step 2 Right-click the green line containing the circuits that you want to view and choose one of the following:

•Circuits—To view MS-SPRing, SNCP ring, 1+1, virtual concatenated (VCAT), or unprotected circuits on the span.

•PCA Circuits—To view circuits routed on an MS-SPRing protected channel. (This option does not appear if the span you right-clicked is not an MS-SPRing span.)

	Cisco ONS 15454 SDH Procedure Guide, R7.2
19-26	October 2007