Cisco Systems D200 manual DLP-D208 Change External Alarms Using the AIC-I Card, 19-6

Chapter 19 DLPs D200 to D299

DLP- D208 Change External Alarms Using the AIC-I Card

DLP-D208 Change External Alarms Using the AIC-I Card

Purpose	This task changes the external alarm settings on the AIC-I card.
Tools/Equipment	None
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 Confirm that external-device relays are wired to the ENVIR ALARMS IN pins on the MIC-A/P Front Mount Electrical Connection (FMEC). See the “DLP-D324 Install Alarm Cables on the MIC-A/P” task on page 20-12for more information.

Step 2 In node view, double-click the AIC-I card to display it in card view.

Step 3 Click the Provisioning > External Alarms tabs.

Step 4 Modify any of the following fields for each external device wired to the ONS 15454 SDH MIC-A/P card. For definitions of these fields, see the “NTP-D247 Provision External Alarms and Controls on the Alarm Interface Controller–International” procedure on page 9-8.

•Enabled

•Alarm Type

•Severity

•Virtual Wire

•Raised When

•Description

Step 5 To provision additional devices, complete Step 4 for each additional device.

Step 6 Click Apply.

Step 7 Return to your originating procedure (NTP).

DLP-D209 Change External Controls Using the AIC-I Card

Purpose	This task changes the external control settings on the AIC-I card.
Tools/Equipment	None
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 Verify the external control relays to the MIC-A/P card connector. See the “DLP-D324 Install Alarm Cables on the MIC-A/P” task on page 20-12for more information.

Step 2 In node view, double-click the AIC-I card to display it in card view.

	Cisco ONS 15454 SDH Procedure Guide, R7.2
19-6	October 2007