Cisco Systems D200 manual J1 Function Cards, 19-69

Chapter 19 DLPs D200 to D299

DLP- D264 Provision a J1 Path Trace on Circuit Source and Destination Ports

DLP-D264 Provision a J1 Path Trace on Circuit Source and Destination Ports

Purpose	This task creates a J1 path trace on VC3 or VC4 circuit source ports and
	destination ports or a VCAT circuit member.
Tools/Equipment	ONS 15454 SDH cards capable of transmitting and/or receiving J1 path
	trace must be installed at the circuit source and destination ports. See
	Table 19-5 on page 19-69for a list of cards.
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Note This task assumes that you are setting up path trace on a bidirectional circuit and setting up transmit strings at the circuit source and destination.

Step 1 From the View menu, choose Go to Network View.

Step 2 Click the Circuits tab.

Step 3 For the VC3 or VC4 circuit you want to monitor, verify that the source and destination ports are on a card that can transmit and receive the path trace string. See Table 19-5for a list of cards.

Table 19-5	ONS 15454 SDH Cards Capable of J1 Path Trace
J1 Function		Cards
Transmit and receive		E1-42
		STM1E-12
		E3-12
		DS3i-N-12
Receive only		OC3 IR 4/STM1 SH 1310
		OC3 IR 4/STM1 SH 1310-8
		OC12/STM4-4
		OC48 IR/STM16 SH AS 1310
		OC48 LR/STM16 LH AS 1550
		OC192 SR/STM64 IO 1310
		OC192 LR/STM64 LH 1550
		OC192 IR/STM SH 1550
		ML100T-12
		ML1000-2
		FC_MR-4

Note For FC_MR-4 cards, the path trace string must be identical for all members of the VCAT circuit.

	Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007		19-69