Cisco Systems D200 manual DLP-D266 Change IP Settings, 19-73, DLP-D60 Log into CTC, page

Chapter 19 DLPs D200 to D299

DLP- D266 Change IP Settings

Step 4 Click Apply.

Step 5 Return to your originating procedure (NTP).

DLP-D266 Change IP Settings

Purpose	This task changes the IP address, subnet mask, default router, DHCP
	access, firewall access, and proxy server settings for the ONS 15454 SDH.
Tools/Equipment	None
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Superuser

Caution Changing the node IP address, subnet mask, or IIOP listener port causes the TCC2/TCC2P cards to reboot. If Ethernet circuits using STP originate or terminate on E-Series Ethernet cards installed in the node, circuit traffic will be lost for several minutes while the spanning trees reconverge. Other circuits are not affected by TCC2/TCC2P card reboots.

Note If the node contains TCC2P cards and is in default (repeater) mode, the node IP address refers to the

TCC2P front-access TCP/IP (LAN) port. If the node is in secure mode, this task will only change the MIC-C/T/P LAN address. If the node is in secure mode and has been locked, the IP address cannot be

changed unless the lock is removed by Cisco Technical Support

Step 1 In node view, click the Provisioning > Network > General tabs.

Step 2 Change any of the following:

•IP Address

•Suppress CTC IP Display

•LCD IP Setting

•Default Router

•Forward DHCP Requests To

•MAC Address

•Net/Subnet Mask Length

•TCC CORBA (IIOP) Listener Port

•Gateway Settings

See the “DLP-D249 Provision IP Settings” task on page 19-53for detailed field descriptions. For more information about secure mode, refer to the “Management Network Connectivity” chapter of the Cisco ONS 15454 SDH Reference Manual.

Step 3 Click Apply.

	Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007		19-73