Cisco Systems D200 DLP-D212 Create a User Data Channel Circuit, 19-9, Purpose, Tools/Equipment

Chapter 19 DLPs D200 to D299

DLP- D212 Create a User Data Channel Circuit

Note Reprovisioning an Ethernet port on the CE-1000-4 card does not reset the Ethernet statistics for that port.

Step 6 Return to your originating procedure (NTP).

DLP-D212 Create a User Data Channel Circuit

	Purpose	This task creates a user data channel (UDC) circuit on the
		ONS 15454 SDH. A UDC circuit allows you to create a dedicated data
		channel between nodes.
	Tools/Equipment	STM cards must be installed.
	Prerequisite Procedures	NTP-D24 Verify Card Installation, page 4-2
		DLP-D60 Log into CTC, page 17-49
	Required/As Needed	As needed
	Onsite/Remote	Onsite or remote
	Security Level	Provisioning or higher
Step 1	In network view, click the Provisioning > Overhead Circuits tabs.
Step 2	Click Create.
Step 3	In the Overhead Circuit Creation dialog box, complete the following fields in the Circuit Attributes area:

•Name—Assign a name to the circuit. The name can be alphanumeric and up to 48 characters (including spaces).

•Type—Choose either User Data-F1or User Data D4-D12from the drop-down list.

Step 4 Click Next.

Step 5 In the Circuit Source area, complete the following:

•Node—Choose the source node.

•Slot—Choose the source slot.

•Port—If displayed, choose the source port.

Step 6 Click Next.

Step 7 In the Circuit Destination area, complete the following:

•Node—Choose the destination node.

•Slot—Choose the destination slot.

•Port—If displayed, choose the destination port.

Step 8 Click Finish.

Step 9 Return to your originating procedure (NTP).

	Cisco ONS 15454 SDH Procedure Guide, R7.2
October 2007		19-9