Linksys
How to use a router as an access point
How can I use this new router as an access point? If you have a large area to cover with your wireless signal, or if part of your home has weak signals due to interference, you can use this router to extend the range of your old router’s wireless network..
For ALL
To set up your new router as an access point:
Setup > Basic Setup
1.Use a network cable to connect this router’s Internet port to the Ethernet or LAN port on the router that is connected to your modem..
2.Log into the
3.Click the Setup tab, then click the Basic Setup page..
4.For Internet Connection Type, select Bridge Mode..
5.Click Save Settings to apply the changes.. The new router’s LAN IP address will be changed and obtained from the router that is connected to your modem..
Important
While in Bridge Mode, the following
•• Setup tab: IPv6 Setup, DDNS, MAC Address Clone, Advanced Routing
•• Security tab: all pages
•• Access Restrictions tab: all pages
•• Applications & Gaming tab: all pages
•• Administration tab: Log
Setting Up: Advanced
For ALL
How can I use my old router as an access point? If you have a large area to cover with your wireless signal, or if part of your home has weak signals due to interference, you can use your old router to extend the range of your wireless network.. This is a complex process, so this procedure assumes that you have some networking knowledge..
Tip
Check the documentation for your old router.. Some brands of routers include either a switch on the outside of the case or a software option to convert it to an access point.. If either of these options is available, follow your old router’s instructions to convert it to an access point..
You need to take note of your new router’s settings, then apply some of those settings to the old router so it can work as an access point..
To view your new router’s settings:
Wireless > Basic Wireless Settings
Wireless > Wireless Security
Wireless > Wireless Settings (E4200)
Status > Wireless Network
Setup > Basic Setup
1.Make sure that your new router is connected to the Internet..
2.In the
3.For the E4200, click Wireless Settings and take note of the Network Name (SSID), Security Mode, and Passphrase..
Or, for other Linksys router models:
a.Click the Basic Wireless Settings page and take note of the Network Name (SSID)..
b.Click the Wireless tab, then click the Wireless Security page and take note of the Security Mode and the passphrase..
4.Click the Status tab, then click the Wireless Network page and take note of the Channel..
5.Click the Setup tab, then click the Basic Setup page and take note of the DHCP server’s IP Address range (192..168..1..100 to 192..168..1..149 by default)
36
