3 Interfaces
3-14 VPN 3000 Concentrator Series User Guide
Configuration | Interfaces | WAN Card in Slot N
The Manager displays this screen when you click the WAN module in the back-panel image on the
Configuration | Interfaces screen. The table shows the status of the WAN module interface ports, and from
there you can choose a port to configure.
Note that the LEDs on this screen do not show actual WAN card LED states.
Figure 3-6: Configuration | Interfaces | WAN Card in Slot N screen
To configure an interface port, either click the link in the status table, or select and click the highlighted
port in the WAN module image. If you are configuring the WAN interface for the first time, see the
Configuration | Interfaces | WAN Card in Slot N | Port A B | Select T1/E1 screen. Otherwise, see the Configuration
| Interfaces | WAN Card in Slot N | Port A B as T1 or E1 screen.
Interface
The interface port on this WAN module.
Status
The operational status of this interface. If the interface is configured, the status includes a prefix if PPP
Multilink is enabled, and the interface type (T1 or E1).
Up = (Green) Configured, enabled, and operational; ready to pass data traffic.
Down = (Red) Configured but disabled or disconnected.
Testing = In test mode; no regular data traffic can pass.
Dormant = (Red) Configured and enabled but waiting for an external action, such as an incoming
connection.
Not Present = (Red) Missing hardware components.
Lower Layer Down = (Red) Not operational because a lower-layer interface is down.
Unknown = (Red) Not configured or not able to determine status.
Not Configured = Present but not configured.