Cisco Systems WSC2960X24PSL Creating an RSPAN Destination Session, remote-span 4. exit, end, Step

Configuring SPAN and RSPAN

Creating an RSPAN Destination Session

Creating an RSPAN Destination Session

You configure an RSPAN destination session on a different switch or switch stack; that is, not the switch or switch stack on which the source session was configured.

Beginning in privileged EXEC mode, follow these steps to define the RSPAN VLAN on that switch, to create an RSPAN destination session, and to specify the source RSPAN VLAN and the destination port.

SUMMARY STEPS

1.configure terminal

2.vlan vlan-id

3.remote-span

4.exit

5.no monitor session {session_number all local remote}

6.monitor session session_number source remote vlan vlan-id

7.monitor session session_number destination interface interface-id

8.end

DETAILED STEPS

	Command or Action	Purpose
Step 1	configure terminal	Enters the global configuration mode.
	Example:
	Switch# configure terminal

Step 2	vlan vlan-id
	Example:
	Switch(config)# vlan 901
Step 3	remote-span
	Example:
	Switch(config-vlan)# remote-span
Step 4	exit
	Example:
	Switch(config-vlan)# exit

Specifies the VLAN ID of the RSPAN VLAN created from the source switch, and enters VLAN configuration mode.

If both switches are participating in VTP and the RSPAN VLAN ID is from 2 to 1005, Steps 2 through 4 are not required because the RSPAN VLAN ID is propagated through the VTP network.

Identifies the VLAN as the RSPAN VLAN.

Returns to global configuration mode.

	Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
88	OL-29044-01