Cisco Systems C2960XSTACK Configuring an FSPAN Session, Enters global configuration mode, Step

Configuring SPAN and RSPAN

Configuring an FSPAN Session

	Command or Action	Purpose
		• (Optional) [, -] Specifies a series or range of interfaces. Enter a space
		before and after the comma; enter a space before and after the hyphen.
		• Enter ingress with additional keywords to enable forwarding of incoming
		traffic on the destination port and to specify the encapsulation type:
		◦dot1q vlan vlan-id—Forwards incoming packets with IEEE 802.1Q
		encapsulation with the specified VLAN as the default VLAN.
		◦isl—Forwards ingress packets with ISL encapsulation.
		◦untagged vlan vlan-idor vlan vlan-id—Forwards incoming
		packets with untagged encapsulation type with the specified VLAN
		as the default VLAN.
Step 5	end	Returns to privileged EXEC mode.
	Example:
	Switch(config)# end

Configuring an FSPAN Session

Beginning in privileged EXEC mode, follow these steps to create a SPAN session, specify the source (monitored) ports or VLANs and the destination (monitoring) ports, and configure FSPAN for the session.

SUMMARY STEPS

1.configure terminal

2.no monitor session {session_number all local remote}

3.monitor session session_number source {interface interface-idvlan vlan-id} [, -] [both rx tx]

4.monitor session session_number destination {interface interface-id[, -] [encapsulation replicate]}

5.monitor session session_number filter {ip ipv6 mac} access-group {access-list-numbername}

6.end

DETAILED STEPS

	Command or Action	Purpose
Step 1	configure terminal	Enters global configuration mode.
	Example:
	Switch# configure terminal

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29044-01 91