Cisco Systems WSC2960X24TSL manual snmp-server enable traps port-security, storm-control, stpx

Configuring Simple Network Management Protocol

Configuring SNMP Notifications

Notification Type Keyword	Description
port-security	Generates SNMP port security traps. You can also set a maximum
	trap rate per second. The range is from 0 to 1000; the default is 0,
	which means that there is no rate limit.
	Note	When you configure a trap by using the notification type
		port-security, configure the port security trap first, and
		then configure the port security trap rate:
	1 snmp-server enable traps port-security
	2 snmp-server enable traps port-security trap-rate rate
rtr	Generates a trap for the SNMP Response Time Reporter (RTR).
snmp	Generates a trap for SNMP-type notifications for authentication,
	cold start, warm start, link up or link down.
storm-control	Generates a trap for SNMP storm-control. You can also set a
	maximum trap rate per minute. The range is from 0 to 1000; the
	default is 0 (no limit is imposed; a trap is sent at every occurrence).
stpx	Generates SNMP STP Extended MIB traps.
syslog	Generates SNMP syslog traps.
tty	Generates a trap for TCP connections. This trap is enabled by default.
vlan-membership	Generates a trap for SNMP VLAN membership changes.
vlancreate	Generates SNMP VLAN created traps.
vlandelete	Generates SNMP VLAN deleted traps.
vtp	Generates a trap for VLAN Trunking Protocol (VTP) changes.

Beginning in privileged EXEC mode, follow these steps to configure the switch to send traps or informs to a host.

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29044-01 57