Cisco Systems WSC2960X24TDL Configuring an FRSPAN Session, access-list-number name, vlan vlan-id

Configuring SPAN and RSPAN

Configuring an FRSPAN Session

Command or Action

Step 5 monitor session session_number filter {ip ipv6 mac} access-group

{access-list-number name}

Example:

Switch(config)# monitor session 2 filter ipv6 access-group 4

Step 6 end

Example:

Switch(config)# end

Purpose

◦(Optional) encapsulation replicate specifies that the destination interface replicates the source interface encapsulation method. If not selected, the default is to send packets in native form (untagged).

Note For local SPAN, you must use the same session number for the source and destination interfaces.

You can use monitor session session_number destination command multiple times to configure multiple destination ports.

Specifies the SPAN session, the types of packets to filter, and the ACLs to use in an FSPAN session.

•For session_number, specify the session number entered in Step 3.

•For access-list-number, specify the ACL number that you want to use to filter traffic.

•For name, specify the ACL name that you want to use to filter traffic.

Returns to privileged EXEC mode.

Configuring an FRSPAN Session

Beginning in privileged EXEC mode, follow these steps to start an RSPAN source session, specify the monitored source and the destination RSPAN VLAN, and configure FRSPAN for the session.

SUMMARY STEPS

1.configure terminal

2.no monitor session {session_number all local remote}

3.monitor session session_number source {interface interface-idvlan vlan-id} [, -] [both rx tx]

4.monitor session session_number destination remote vlan vlan-id

5.vlan vlan-id

6.remote-span

7.exit

8.monitor session session_number filter {ip ipv6 mac} access-group {access-list-numbername}

9.end

Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX

OL-29044-01 93