Cisco Systems WSC2960X48TSL configure terminal 2. cns template connect name, cli config-text, end

Configuring Cisco IOS Configuration Engine

Enabling an Initial Configuration for Cisco IOS CNS Agent

SUMMARY STEPS

1.configure terminal

2.cns template connect name

3.cli config-text

4.Repeat Steps 2 to 3 to configure another CNS connect template.

5.exit

6.cns connect name [retries number] [retry-interval seconds] [sleep seconds] [timeout seconds]

7.discover {controller controller-typedlci [subinterface subinterface-number] interface [interface-type] line line-type}

8.template name [... name]

9.Repeat Steps 7 to 8 to specify more interface parameters and CNS connect templates in the CNS connect profile.

10.exit

11.hostname name

12.ip route network-number

13.cns id interface num {dns-reverse ipaddress mac-address} [event] [image]

14.cns id {hardware-serial hostname string string udi} [event] [image]

15.cns config initial {hostname ip-address}[port-number] [event] [no-persist] [page page] [source ip-address][syntax-check]

16.end

DETAILED STEPS

	Command or Action	Purpose
Step 1	configure terminal	Enters the global configuration mode.

Example:

Switch# configure terminal

Step 2	cns template connect name	Enters CNS template connect configuration mode, and specifies the name
		of the CNS connect template.
	Example:
	Switch(config)# cns template connect
	template-dhcp
Step 3	cli config-text	Enters a command line for the CNS connect template. Repeat this step for
		each command line in the template.
	Example:

Switch(config-tmpl-conn)# cli ip address dhcp

Step 4 Repeat Steps 2 to 3 to configure another

CNS connect template.

	Catalyst 2960-X Switch Network Management Configuration Guide, Cisco IOS Release 15.0(2)EX
24	OL-29044-01