
ESC DC3 n
[Function] | Printing the message | |
[Code] | <1B>H <13>H n | |
[Range] | 1 ≤ n ≤ 10 | |
[Function] | This command prints a message. If the value of n is specified beyond the range, or if the | |
| message is not registered yet the message will not be printed. | |
ESC "y" n |
|
|
|
|
|
[Function] | Setting the print lines after paper near end detection | |
[Code] | <1B>H<79>H n | |
[Range] | 0 ≤ n ≤ 255 | |
[Outline] | This command sets the number of print lines after paper near end detection. It stops printing | |
| after printing n × 2 lines since detection of the paper near end, resulting in the paper near end | |
| state (See 4.11 Operation Panel and Display of Error). The PE signal (parallel interface only) | |
| changes when the paper near end is detected. | |
[Caution] | This command is only valid if the paper near end is selected with ESC c4 n, the command to | |
| select the paper near end sensor valid for print stop. | |
[Default] | n = 0 |