ESC 3 n
[Function] | Setting line feed rate of minimum pitch |
[Code] | <1B>H<33>H<n> |
[Range] | 0 n 255 |
[Outline] | Sets the line feed width per line to [n ⋅ basic calculation pitch] |
| inches. |
[Caution] | The line feed width can be set separately for the STANDARD |
| and PAGE MODES. |
| The basic calculation pitch is set by GS P. Once defined, the line |
| feed width is not changed if the basic calculation pitch is changed |
| by GS P. |
| Fractions resulting from calculation are corrected with the |
| minimum pitch of the mechanism, and the remainder is omitted. |
| • In STANDARD MODE, this command uses the vertical (Paper |
| feed direction) basic calculation pitch (y). |
| • In PAGE MODE, this command acts differently depending on |
| the start point: |
| (1) If the start point specified by ESC T is top left or bottom |
| right, the command uses the vertical (Paper feed direction) |
| basic calculation pitch (y). |
| (2) If the start point specified by ESC T is top right or bottom |
| left, the command uses the horizontal (Perpendicular to |
| the paper feed direction) basic calculation pitch (x). |
| The maximum settable line feed width is 1016 mm (40 inches). |
| A setting greater than this maximum is trimmed to the |
| maximum. |
[Default] | Approx 4.23 mm |
[See Also] | ESC 2, GS P |
— 28 —
