ESC SP n
[Function] | Setting the right spacing of the character |
[Code] | <1B>H<20>H<n> |
[Range] | 0 n 255 |
[Outline] | Sets the right spacing of character to [n ⋅ basic calculation pitch] |
| inches. |
[Caution] | • If the horizontal magnification of character is 2 or more, the |
| right spacing increases with the magnification. |
| • The right spacing can be set separately for the STANDARD |
| and PAGE MODES. |
| • The basic calculation pitch is set by GS P. Once defined, the |
| right spacing is not changed if the basic calculation pitch is |
| changed by GS P. |
| • Fractions resulting from calculation are corrected with the |
| minimum pitch of the mechanism, and the remainder is |
| omitted. |
| • In STANDARD MODE, this command uses the horizontal basic |
| calculation pitch (x). |
| • In PAGE MODE, the basic calculation pitch used by this |
| command depends on the start point: |
| (1) If the start point specified by ESC T is top left or bottom |
| right, the command uses the horizontal basic calculation |
| pitch (x). |
| (2) If the start point specified by ESC T is top right or bottom |
| left, the command uses the vertical basic calculation pitch |
| (y). |
| • The maximum right spacing is capable of approximately 31.906 |
| mm (255/203 inches). A setting greater than this maximum is |
| trimmed to the maximum. |
[Default] | n = 0 |
[See Also] | GS P |
— 15 —
