ESC J n
[Function] | Printing and feeding paper in minimum pitch | |
[Code] | <1B>H<4A>H<n> | |
[Range] | 0 n | 255 |
[Outline] | Prints the data held in the print buffer and feeds paper by [n ⋅ | |
| basic calculation pitch] inches. The beginning of the line is taken | |
| as the | next print start position. |
[Caution] | The line feed width can be set separately for the STANDARD | |
| and PAGE MODES. | |
| • This command does not affect the line feed width defined by | |
| ESC 2 or ESC 3. | |
| • The basic calculation pitch is set by GS P. | |
| • Fractions resulting from calculation are corrected with the | |
| minimum pitch of the mechanism, and the remainder is | |
| omitted. | |
| • In STANDARD MODE, this command uses the vertical (Paper | |
| feed direction) basic calculation pitch (y). | |
| • In PAGE MODE, this command acts differently depending on | |
| the start point: | |
| (1) If the start point specified by ESC T is top left or bottom | |
| right, the command uses the vertical (Paper feed direction) | |
| basic calculation pitch (y). | |
| (2) If the start point specified by ESC T is top right or bottom | |
| left, the command uses the horizontal (Perpendicular to the | |
| paper feed direction) basic calculation pitch (x). | |
| The maximum settable line feed width is 1016 mm (40 inches). | |
| A setting greater than this maximum is trimmed to the | |
| maximum. The beginning of the line is taken as the next print | |
| start position. | |
[Default] | The initial value is not defined. | |
[Sample Program] | Refer to Sample Program and Print Results for ESC 2 on | |
| page 29. | |
— 35 —
