(2)If a sufficient area cannot be provided as a result of step (1), the print area is extended toward the left (So, the left margin is decreased).
Printable Area
A | (1) |
Extended | |
| toward |
| the right |
Left Margin | (2) The left margin |
|
| is trimmed | Print Area Width |
(3)If a sufficient area cannot be provided as a result of step (2), the right spacing is trimmed.
•When mapping a bit image (Or downloaded bit image), if the print area is narrower than the minimum width of the bit image (Two dots for single density, or one dot for double density), only the line for that image is handled as follows:
(1)The print area is extended toward the left (So, the left margin is decreased) until it is equal to the minimum width of the image, but not wider than the printable area.
[Default] | nL=64, nH=2 (When 58mm wide paper is used: nL=176, nH=1) |
| Since the default value varies depending on the number of |
| columns, refer to “Defing the print area in PAGE MODE; ESC |
| W”on page 44, for more information. |
[See Also] | GS L, GS P |
— 74 —
