Classe Audio SSP-800 Hardware setup, Classé Delta Series Products, Category 5 Network Cables

hardware setup

1Classé Delta Series Products

Two or more Classé Delta series products are required, at least one of which must have a touchscreen display.

2Category 5 Network Cables

These are ordinary network cables, commonly used for broadband Internet connections. They should be typical “straight through” cables not the “crossed over” type, and the total required will be one less than the total number of Delta series components in your system.

3CAN-Bus Terminator

At minimum, a single CAN-Bus Terminator will be required. It is inserted into the CAN-Bus OUT connector of the last component in the CAN-Bus daisy chain. One is included in the box with your SSP-800. They are also available free of charge from your nearest Classé Customer Support Centre http://www.Classeaudio.com/support/service.htm

4SSP-300 & 600 CAN-Bus Interface Box

Systems that include an SSP-600 or SSP-300 will also require an SSP-300/600 CAN-Bus Interface Box. These are included with the products or available free of charge from your nearest Classé Customer Support Centre http://www.Classeaudio.com/support/service.htm

The diagrams below illustrate how to connect the CAN-Bus hardware.

Any combination of models in any order without SSP-300 or SSP-600.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

Any combination of models in any order with SSP-300 or SSP-600.

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

CAN-BUS

IN OUT

NOTE: Daisy chain must be terminated with CAN-Bus Terminator.

55