ClearOne comm 900 Product Overview, RF Radio Frequency Controller, Mixer, Key Functions, Front

4 Introduction — Product Overview

Product Overview

RF (Radio Frequency) Controller

The RF controller allows you to manage all calls, program user preferences and adjust settings for your RAV.

MUTE	MENU	DOWN	UP
	ENTER

			1	2	3
		CONFERENCE		ABC	DEF	PHONEBOOK
						CLEAR
			4	5	6
			GHI	JKL	MNO
			7	8	9
ON/OFF	FLASH	REDIAL	PQRS	TUV	WXYZ	DOWN	UP
			*	0	#		VOLUME
				HELP	PAUSE
				LINE

Key Functions

LCD Icon		Function
		Indicates commands are received and acknowledged by base unit
ANTENNA		and represents the signal strength from the base unit to the controller.
SIGNAL
		Indicates battery level
BATTERY
	Key	Function

Press to activate the phone and access the dial tone. Press again to hang up the phone.

ON/OFF

Press to use call forwarding, access call waiting, or make a three-way conference call (if supported by your telephone service).

FLASH

	Press once to mute microphones during a call.
MUTE	Press again to unmute.
	Press and hold for two seconds to display the status of the RAV.
STATUS
	Press once to dial the last number called.
REDIAL
	Press once to access the controller programming menu.
MENU	Once you are in the Menu, this key serves as the Enter key.
ENTER
	Press once to dial stored numbers.
PHONEBOOK	When you are in the Phonebook, use this key to delete characters or to
	go back to the previous screen.
CLEAR

Press down or up to navigate through the menu and phonebook.

DOWN UP

Press while on a call to adjust call volume and ringer.

VOLUME

Introduction— Product Overview 5

Mixer

Front

A BC D

Figure 1.2. Mixer front

A.Telephone LED.This indicator lights red when the RAV is powered, but the telco is on hook (not in use).The indicator lights green when the telco is off hook (in use) and flashes green during an incoming call.

B.Microphone status LEDs. Nine indicators (RAV 900) or six indicators (RAV 600) indicate the activation status of the microphone elements. When a microphone element is activated, the corresponding LED lights green. When microphones are muted, all LEDs turn red.

C.Meter LEDs. These LEDs represents audio from all inputs.

D.USB port.This port enables USB connection to a PC.

Back

ANTENNA

Figure 1.3. Mixer back

A.Telephone Set, Line. RJ-11 connection to an analog telephone jack and an analog telephone set.

B.RF antenna connector. Connect the external RF antenna to this port.

C.RS-232. RS-232 control port for connection to a control system such as AMX or Crestron or to a computer.

D.Camera Control. VISCA camera control port.This connection enables microphone activa- tion to trigger camera presets (voice tracking).

E.LAN.This is a 10/100 BaseT auto-detecting Ethernet port for system control through a data network.

F.Mic Pod In. Use a Cat. 5 cable with RJ-45 connectors to connect the microphone pods.

G.Playback In/Record Out. RCA connection to record/playback devices such as a VCR.

H.Line In/Out. RCA connection to a codec, amplifier or sound card.

I.Speaker Output. Use speaker wire to connect these push terminals to the Bose loudspeakers.

J.Power 12 VDC. Power supply.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760 Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760