ClearOne comm AP10 operation manual Installation, Hardware Setup, Connect the unit, AP800

CHAPTER 2: Installation

The AP10 is designed for easy installation and set-up. All connections are made through rear-panel connectors. This section provides instructions on installing the units in the rack and making initial connections, creating a G-Link network, and assigning device ID numbers.

The diagram below illustrates the typical connections that are made when adding an AP10 to an AP800.

Microphones	Touch panel
	controller

AP800 Inputs

AP10

G-Link connection
Receive	Transmit	Telephone set
		(optional)
Output	Input

Line

Figure 2.1. System diagram

Hardware Setup

Connect the unit

Refer to the rear-panel drawing in Figure 2.2 on the following page. Each connector is numbered for easy identification.

1.Place the unit in the rack and attach it securely. AP10 models are designed for installation in a standard 19-inch equipment rack.

2.Connect your telephone line from the wall jack to the RJ-11C Line jack [F].

3.Plug your telephone set into the RJ-11C Set jack [G].

4.If you are using a custom controller for control and hybrid status, plug it into the DB-25 Remote connector [C].

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760