Command form Device Terle | ClearOne comm AP10 instruction

Appendices ~ Appendix C: Serial Commands

27

TERLE

This command reports back the telephone echo return loss enhancement (ERLE) for the AP10 in dB. This is a read-only parameter.

Command form: DEVICE TERLE

Return values: If the current TERLE level for the telephone canceller is 20dB, the

following is returned out the serial port: DEVICE TERLE 20

UID

This command returns the unique ID number of the unit. This command is read-only.

Command form: DEVICE UID

Return values: UID returns the unit ID code. The Unit ID is composed of an eight- digit hex number (assigned at the factory) to uniquely identify the unit.

Example:
To request the unit ID:	#20 UID
The following is returned out the serial port:	#20 UID A4EF906C

VER

This command returns current version of firmware. This version is unique to a released version of firmware. This command is read-only.

Command form: DEVICE VER

Return values: VER returns the version of firmware (a major version number followed by a period and a minor version number).

Example:
To request the unit ID from device 20	#20 VER
The following is returned out the serial port:	#20 VER 1.1

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 31

ClearOne comm AP10 operation manual Command form Device Terle, Command form Device UID, Command form Device VER

Contents

AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of Contents Operation Appendices Introduction Features ClearOne Communications EuMEA GmbH Professional Services GroupSales and Customer Service Technical Support Introduction ~ Controls and Connections UnpackingControls and Connections Front view Rear view AP10 rear-panel connectors Telephone line requirements Before You InstallPower requirements Equipment placement Technical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware Setup Phoenix connector Installation ~ Hardware SetupCreating a G-Link network Assigning device ID numbers Connecting powerDevice ID DIP switch settings Binary DIP Switch Address Position Technical Services Group ~ 1-800-283-5936 USA ~ Noise burst/auto-adapt DIP Switch SettingsReceive boost Call progression/loop Receive AGCAuto-answer Auto-disconnect Ringing Receive reductionCalibration Noise burst adapt Receive level adjustment Transmit level adjustmentAuto-adapt To answer a call Using the AP10To make and disconnect a call Found Using the Telco Interface Custom control through DB-25 port To muteOther telco options Controllers Technical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a Specifications Pin Description Remote connector pinoutAppendix B Pinouts Appendices ~ Appendix B Pinouts Conventions Set connector pinoutLine connector pinout Appendix C Serial Commands Example Command structureConvention Description Command form Device AA AP10 Serial CommandsAppendices ~ Appendix C Serial Commands Command Function Command form Device Hookd Command form Device HookExample Command form Device Mute CH Explanation Command form Device LVL CH Return values Command form Device NullCommand form Device TE Command form Device Terl Return values Command form Device UID Command form Device TerleCommand form Device VER This Warranty is Void if Appendix D Warranty Appendices ~ Appendix D Warranty Usoc Jacks This device uses RJ-11C and RJ21X terminal jacks Appendix E ComplianceFCC Part 15 Compliance FCC Part 68 Compliance IC Compliance Safety InformationAppendices ~ Appendix E Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AEC Glossary Index Index