CHAPTER 3: Configuration

DIP Switch Settings

The AP10 has a variety of operational features configurable through DIP switch settings, including noise burst/auto-adapt, receive AGC control, auto-answer, auto- disconnect, call progression/loop, receive reduction, and hook-flash duration. Default settings (as shipped from the factory) are denoted by an asterisk “*”.

Figure 3.1. AP10 DIP switches

Noise burst/auto-adapt

In some applications, you might want to adapt the hybrid with a white noise burst, rather than allow the hybrid to adapt automatically to line conditions. To enable this feature, set DIP switch 1 to the On position.

DIP Switch

Position

Description

1

On (up)

Burst adapt

1*

Off (down)

Auto-adapt

Receive boost

If incoming caller audio is consistently low, activate the Receive Boost. This will increase receive audio by 6dB. To enable this feature, set DIP switch 2 to the On position.

DIP Switch

Position

Description

2

On (up)

6dB Receive audio boost enabled

2*

Off (down)

6dB Receive audio boost disabled

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Page 15
Image 15
ClearOne comm AP10 operation manual DIP Switch Settings, Noise burst/auto-adapt, Receive boost