Introduction, Features | ClearOne comm AP10 manual

CHAPTER 1: Introduction

Congratulations on purchasing the Audio Perfect® telephone interface. The AP10 uses advanced digital technology to maintain the highest possible audio quality. The AP10 is designed as an accessory to the AP800 (echo cancelling, audio processing, microphone mixing matrix) and enables the AP800 to connect to a standard telephone line.

The AP10 is a single-line digital hybrid which uses digital signal processing (DSP) to separate the transmit and receive audio—eliminating distortion, weak signals, and feedback. It continually filters low and high frequency noise to provide pure sound.

Features

•Easy to install and operate

•DTMF dialing capability

•Simultaneous two-wire/four-wire operation within an Audio Perfect system

•G-Link network interconnection with up to eight AP800s and 16 AP10s

•9.6kHz sampling rate allows continual adaptation to telephone-line conditions

•Full-time telco echo cancellation with 26 millisecond tail time

•Conference up to 16 callers (with 16 AP10s) within an Audio Perfect system

•Digital anti-alias filter minimizes hum and Central Office switching noise

•Remote On/Off control via serial commands or rear-panel connection

•Digital send filter/limiter for telephone line noise reduction

•Compatible with any analog telephone system

•No outside RF interference will affect performance

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 5

ClearOne comm AP10 operation manual Introduction, Features

Contents

AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Iii Table of Contents Operation Appendices Introduction Features Sales and Customer Service Professional Services GroupTechnical Support ClearOne Communications EuMEA GmbH Controls and Connections UnpackingFront view Introduction ~ Controls and Connections Rear view AP10 rear-panel connectors Power requirements Before You InstallEquipment placement Telephone line requirements Technical Services Group ~ 1-800-283-5936 USA ~ Connect the unit Hardware Setup Creating a G-Link network Installation ~ Hardware SetupPhoenix connector Device ID DIP switch settings Connecting powerBinary DIP Switch Address Position Assigning device ID numbers Technical Services Group ~ 1-800-283-5936 USA ~ Receive boost DIP Switch SettingsNoise burst/auto-adapt Auto-answer Receive AGCAuto-disconnect Call progression/loop Calibration Receive reductionNoise burst adapt Ringing Auto-adapt Transmit level adjustmentReceive level adjustment To make and disconnect a call Using the AP10To answer a call Found Using the Telco Interface Other telco options To muteControllers Custom control through DB-25 port Technical Services Group ~ 1-800-283-5936 USA ~ Appendices Appendix a Specifications Appendix B Pinouts Remote connector pinoutAppendices ~ Appendix B Pinouts Pin Description Line connector pinout Set connector pinoutAppendix C Serial Commands Conventions Convention Description Command structureExample Appendices ~ Appendix C Serial Commands AP10 Serial CommandsCommand Function Command form Device AA Example Command form Device HookCommand form Device Hookd Command form Device Mute CH Explanation Command form Device LVL CH Command form Device TE Command form Device NullCommand form Device Terl Return values Return values Command form Device VER Command form Device TerleCommand form Device UID This Warranty is Void if Appendix D Warranty Appendices ~ Appendix D Warranty FCC Part 15 Compliance Appendix E ComplianceFCC Part 68 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacks Appendices ~ Appendix E Compliance Safety InformationIC Compliance Appendix F Block Diagram Glossary Acoustic Echo Cancellation AEC Glossary Index Index