Auto-adapt, Transmit level adjustment | ClearOne comm AP10 specs

14	Configuration ~ Calibration

AP10 transmit and receive
✍ audio	level	adjustments
are	made	using	the
AP800. Nominal transmit			and

receive level for the AP10 is 0dBu.

Auto-adapt

If DIP switch 1 is off (down), call someone and continue to talk while the system gradually adapts over time. Once complete, the AP10 will be fully calibrated and ready for use. Press the Off button [E]. If the auto-disconnect feature is active, and the caller hangs up, the AP10 will disconnect upon sensing loop drop or call- progress tones, depending on the position of DIP switch 6.

Transmit level adjustment

Someone in the local room should speak into the microphone at a normal distance, in a normal voice. The party at the distant location should not speak during the transmit adjustment. Adjust the AP800 output that is connected to the AP10 Transmit input to 0dB. The AP10 Transmit LED [B] should illuminate solid green while the person is speaking and extinguish when the person stops.

Receive level adjustment

Someone in the distant location should speak into the microphone at a normal distance, in a normal voice; the local room should maintain silence. Adjust the AP800 input that is connected to the AP10 Receive output to 0dB. The AP10 Receive LED [C] should be solid green while the person is speaking and extinguish when the person stops.

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Image 18

ClearOne comm AP10 operation manual Auto-adapt, Transmit level adjustment, Receive level adjustment

Contents

AP10 Telephone Interface Technical Services Group ~ 1-800-283-5936 USA ~ Table of Contents Iii Appendices Operation Features Introduction Technical Support Professional Services GroupSales and Customer Service ClearOne Communications EuMEA GmbH Front view UnpackingControls and Connections Introduction ~ Controls and Connections AP10 rear-panel connectors Rear view Equipment placement Before You InstallPower requirements Telephone line requirements Technical Services Group ~ 1-800-283-5936 USA ~ Hardware Setup Connect the unit Installation ~ Hardware Setup Phoenix connectorCreating a G-Link network Binary DIP Switch Address Position Connecting powerDevice ID DIP switch settings Assigning device ID numbers Technical Services Group ~ 1-800-283-5936 USA ~ DIP Switch Settings Noise burst/auto-adaptReceive boost Auto-disconnect Receive AGCAuto-answer Call progression/loop Noise burst adapt Receive reductionCalibration Ringing Transmit level adjustment Receive level adjustmentAuto-adapt Using the AP10 To answer a callTo make and disconnect a call Using the Telco Interface Found Controllers To muteOther telco options Custom control through DB-25 port Technical Services Group ~ 1-800-283-5936 USA ~ Appendix a Specifications Appendices Appendices ~ Appendix B Pinouts Remote connector pinoutAppendix B Pinouts Pin Description Appendix C Serial Commands Set connector pinoutLine connector pinout Conventions Command structure ExampleConvention Description Command Function AP10 Serial CommandsAppendices ~ Appendix C Serial Commands Command form Device AA Command form Device Hook Command form Device HookdExample Command form Device LVL CH Command form Device Mute CH Explanation Command form Device Terl Return values Command form Device NullCommand form Device TE Return values Command form Device Terle Command form Device UIDCommand form Device VER Appendix D Warranty This Warranty is Void if Appendices ~ Appendix D Warranty FCC Part 68 Compliance Appendix E ComplianceFCC Part 15 Compliance Usoc Jacks This device uses RJ-11C and RJ21X terminal jacks Safety Information IC ComplianceAppendices ~ Appendix E Compliance Appendix F Block Diagram Acoustic Echo Cancellation AEC Glossary Glossary Index Index