12

Configuration ~ DIP Switch Settings

To issue the AA (auto- answer) serial command to toggle auto-answer, DIP

switch 4 must be off (down).

Receive AGC

DIP switch 3 enables/disables the automatic gain control (AGC) function in the firmware. The AGC feature is designed to keep soft and loud telephone participants at a consistent level.

DIP Switch

Position

Description

3*

On (up)

Receive AGC enabled

3

Off (down)

Receive AGC disabled

Auto-answer

DIP switch 4 enables/disables auto-answer. When enabled, the AP10 will automatically answer incoming calls after one complete valid ring has been detected.

DIP Switch

Position

Description

4

On (up)

Auto-answer enabled

4*

Off (down)

Auto-answer disabled (follows

 

 

the serial command)

Auto-disconnect

DIP switch 5 enables/disables auto-disconnect.

DIP Switch

Position

Description

5*

On (up)

Auto-disconnect enabled

5

Off (down)

Auto-disconnect disabled

In order for the settings on

DIP Switch

6 to function,

 

DIP Switch 5 must be on

(up). Auto-disconnect must

be

enabled

before

either

Call

Progression or Loop Drop are applicable.

Call progression/loop

DIP switch 6 selects either loop drop or call-progress mode. Call-progress mode will disconnect the line upon detection of a valid call-progress signal. Call progress will detect the reorder tone and busy signal for the U.S., Canada, United Kingdom, France, and Germany.

DIP Switch

Position

Description

6

On (up)

Call progression enabled

6*

Off (down)

Loop drop enabled

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Page 16
Image 16
ClearOne comm AP10 operation manual Receive AGC, Auto-answer, Auto-disconnect, Call progression/loop