5.Holding the base slightly above the mounting screws on the wall jack, push the base against the mounting screws so they are hooked into the left and right keyhole slots on the back of the phone. Slowly slide the base down until it snaps into place.

6.Plug the AC power adapter into the electrical outlet. CAUTION: To reduce risk of personal injury, fire, or damage use only the adapter provided.

Installing Batteries Three AAA re-chargeable Ni-MH batteries come with your phone. You must install the batteries before using your phone.

1.Remove the battery compartment cover by sliding it downwards.

2.Insert the new batteries. Be sure to observe battery polarity as imprinted on the inside of

the compartment.

3.Replace the battery compartment cover by sliding upward until it clicks into place.

NOTE: The batteries need to be replaced if they do not recover their full storage capacity after recharging. Check the battery icon on the LCD to see the battery charge level. When replacing the batteries, always use good quality Ni-MH AAA re-chargeable batteries.

15 – ENGLISH

Page 15
Image 15
ClearSounds A600 manual English