Cobalt Networks 9084 instruction

3			Color and Video Correction Examples Using the 9084

		Table 3-3 Color and Video Corrections Using the 9084 — continued

		Condition Observed On Waveform Monitor	Correction Using 9084

		White (luma) level exceeding 100% level (as shown	Using the White Hard Clip control, a lowered white hard
		below for limit ramp monochrome bars on waveform	clipping threshold is applied to now limit the level to 100%.
		monitor display)

VAR4.PNG
VAR4.PNG		VAR4A.PNG

White (luma) level exceeding 100% level (as shown	Using the White Soft Clip control, a lowered white soft
below for limit ramp monochrome bars on waveform	clipping threshold is applied to now limit the level to 100%.
monitor display)

VAR5.PNG		VAR5A.PNG

Luma gain less than 100% level (as shown below for	Using the Luma Gain control to increase luma gain, luma
100% color bars on YPbPr waveform monitor display)	gain is now restored to 100%.

VAR9.PNG

VAR9A.PNG

3-32

9084 PRODUCT MANUAL

9084-OM (V4.0)

Image 56

Cobalt Networks 9084 manual Luma gain less than 100% level as shown below for

Contents

9084 Cobalt Digital Inc Trademark Information CopyrightDisclaimer Table of Contents Operating Instructions Introduction Overview Card Software Versions and this Manual SupportDownloads link at Manual Conventions E201 Safety Summary Labeling Symbol Definitions Functional Description Input/Outputs Color Corrector ProcessorVideo Color Corrector Video ProcessorFrame Sync Function AFD Inserter Computer with NIC DashBoard Remote Control User Control InterfaceCard Edge Controls Controller Card Other cards installed in openGear frames such as the Cobalt Raster Structure Frame Rate Rear I/O ModulesVideo Formats Supported by Technical Specifications Characteristic Technical Specifications Introduction Warranty and Service Information Cobalt Digital Inc. Limited Warranty Contact Cobalt Digital Inc PhoneFax Web General Information Technical Support This page intentionally blank Installation and Setup Installing the 9084 Into a Frame Slot Installing the 9084 Into a Frame Slot Installation and Setup Installing a Rear I/O Module Setting Up 9084 Network Remote Control Rear I/O Module Installation Operating Instructions Control and Display Descriptions Function Submenu/Parameter Submenu Overview Submenu a Submenu b Submenu z Individual Parameters Card Edge Controls, Indicators, and Display Function None Card Edge Control Menu/Submenu StructureMenu Depth LEDs Card Edge Setup Abbreviated Diagram VidSubmenu Depth ClrC S p DashBoard User Interface Correction Set Enable to OnChannel Black Adj Cobalt Remote Control Panel User Interfaces Control Panel Setup of Example Video Proc Function Accessing the 9084 Card via Remote Control Accessing the 9084 Card Using DashBoard Accessing the 9084 Card Using a Cobalt Remote Control Panel Checking Card Using Info Card Edge Controls Power Consumption and Temperature DisplaysChecking 9084 Card Information Software Version Number Default Line No. / Range Ancillary Data Line Number Locations and RangesFormat Line No. Limiting Format Function Submenu List and Descriptions Function Submenu Item Reset to Unity Video ProcLuma Gain Luma Lift Color Phase Color GainGang Luma and Color Gain Black Hard Clip Applies white hard clip limiting at specified percentage 50.0% to 109.1% null = 109.1%Card Edge Control Menu Applies white soft clip limiting at specified percentage Output Mode Incoming AFDOutput Code Output Line Operating Instructions Black Adj. Green Red Blue Gang Black Level Controls White Adj. Green Red Blue Gang Gamma Controls Horizontal Delay Control Framesync EnableVertical Delay Control Video Delay Display Loss of Input Signal SelectionMinimum Latency Frames Control Framesync Status Display Reset Framesync Framesync LOS Freeze ColorCustom Color Hue Custom Color Saturation Preset Name field and Preset Save button Preset Load button and the Selected PresetPreset Save and Load Selected Preset drop-down list Reset Current Preset Function Parameter/Setting Video ProcPreset Name Download Presets Color and Video Correction Examples Using Feed To SwitcherOn-Set Monitor Color Correction Example Anchor Desk Set with Monitor 10 Uncorrected Uncompensated Monitor Waveform To Switcher From Monitor Video Feed 12 Applying Correction to Example Monitor Waveform Signal Condition Observed On Waveform Monitor Correction Using Miscellaneous Color and Video Correction Examples Luma gain less than 100% level as shown below for VAR10.PNG VAR10A.PNG Troubleshooting Error and Failure Indicator Overview Card Edge Status/Error Indicators and Display Status/Error Input Format Indicators IndicatorsCharacter Alphanumeric Display Alphanumeric DashBoard Status/Error Indicators and Displays Indicator Icon or Display Error Description 15 Selecting Specific Cards for Card Info Status Display Basic Troubleshooting Checks Checks Processing Error Troubleshooting Symptom Error/Condition Corrective Action Troubleshooting Network/Remote Control Errors Case of ProblemsPage 2406 E. University Ave. Urbana, IL 9084-OM