Maintenance and Service Guide B–1
B

Power Cord Set Requirements

3-Conductor Power Cord Set

The computer’swide range input feature permits it to operate
from any line voltagefrom 100 to 120 or 220 to 240 volts AC.
The powercord set received with the computer meets the
requirements for use in the country where the equipment is
purchased.
Powerc ords ets for use in other countries must meet the
requirementsof the country where the computer is used. For more
information on powercord set requirements, contact a Compaq
authorized reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
The length of the powercord set must be at least 5.00 feet
(1.5 m) and a maximum of 6.50 feet (2.0 m).
All powercord sets must be approvedby an acceptable
accredited agency responsible for evaluationin the country
where the powercord s et will be used.
The powercord set must have a minimum current capacity of
10A and a nominal voltage rating of 125 or250 volts AC, as
required by each country’spower system.
The appliance coupler must meet the mechanical
configurationof an EN 60 320/IEC 320 Standard Sheet C13
connector,for mating with appliance inlet on the back of the
computer.