MOTOR(13/6.5AMP)- Powersthe blade and is
controlled by the switch and key at the front of the arm. The powerful induction motor has a capacitor start. It is mounted in the yoke and rotated with the bevel index knob and bevel lock lever. See Figure 9B.
RIP SCALES - Show the distance from the fence to. the blade.
RIVING KNIFE OR SPREADER - Located directly in front of the blade and beside the
RIVING KNIFE BRACKET - Allows adjustment of the riving knife. Located midway along the riving knife. See Figure 9D.
RIVING KNIFE KNOB - Adjusts the riving knife and locks both the pawls and the riving knife in place. Located toward the top and front of the blade guard, See Figure 9D.
DUSTGUIDE
HOLDDOWN
HOLD
DOWNKNOB
UPPER
BLADEGUARD
LOWER
BLADEGUARD
SWITCH TRIGGER - Used to power the control cut device to allow yoke assembly to be pulled forward. Mounted in the handle. See Figure 9D.
SWITCH WITH KEY - Powers the blade motor. Placed on the front of the arm for easy access. To lock the switch once it has been pressed to OFF, remove the yellow key. Place the key in a location that is inaccessible to children and others not qualified to use the tool. See Figures 9A and 9C.
YOKE - Supports the blade and motor. Can be pivoted to index the blade between rip and cross cuts. Located between the carriage and the motor. See
Figure 9B.
YOKE PIVOT LATCH - Indexes the yoke (after it is released) to position the blade to face right
YOKE LOCK HANDLE - Releases the yoke to allow indexing for rip cut or cross cut. Located below the yoke, on the right. See Figure 9B.
BLADEGUARD
CLAMPSCREW
SWITCH
RIVING
KNIFEKNOB
RIVINGKNIFE
RIVING
'_' KNIFEBRACKET
PAWLS
BLADE
_Fig.9D
CRAFTSMRN'RADIALSAW315.220380
