EXTENSION CORDS

Use only 3-wire extension cords that have 3-prong
grounding plugs and 3-pole receptacles that accept
thetool's plug. When using a power tool at a consider-
able distance from the power source, use an exten-
sioncord heavy enough to carry the current that the
tool will draw. An undersized extension cord will
cause a drop in line voltage, resulting in a loss of
power and causing the motor to overheat. Use the
chart provided below to determine the minimum wire
size required in an extension cord. Only round jack°
eted cords listed by Underwriter's Laboratories (UL)
should be used,
Length of Extension Cord Wire Size (A.W.G.)
Up to 25 .feet 14
26-100 feet 12
When working with the tool outdoors, use an exten-
sioncord that is designed for outside use. This is
indicated by the letters WA on the cord's jacket.
Before using an extension cord, inspectit for loose or
exposed wires and cut or worn insulation.
,_ CAUTION: Keep the cord away from the cutting
area and position the cord so that it will not be
caught on lumber, tools, or other objects during
cutting operations.

ELECTRICAL CONNECTION

Your Sears Craftsman Radial Arm Saw is powered by
a precision built electric motor. It should be connected
to a power supply that is 120 volts, 60 Hz, AC only
(normal household current). It should be connected
to a240 volt power supply only If It has been reset
according to the instructions inthis manual. The
motor has been set at the factory for 120 volts; ifit is
reconnected to operate at 240 volts, the main power
cord plug and any receptacle must be replaced with
devices rated for 240 volts. This tool will not operate
on direct current (DC). A substantialvoltage drop will
cause a loss of power and the motor willoverheat. If
the saw does not operate when plugged into an outlet,
double check the power supply.
SPEED AND WIRING
The no-load speed of your saw is approximately 3,600
rpm.This speed is not constant. For voltage, the
wiringin a shop is as importantas the motor's horse-
power rating. A line intended onlyfor lights cannot
properly carrya power tool motor. Wire that is heavy
enough for a short distance will be too light for a
greater distance. A line that can support one power
tool may not be able to support two or three tools.

GROUNDING INSTRUCTIONS

Inthe event of amalfunction orbreakdown, grounding
providesa path of least resistance for electric current
to reduce the riskof electric shock. This tool is
equipped withan electric cord having an equipment-
grounding conductor and a grounding plug. The plug
must be plugged into a matching outlet that is properly
installed and grounded in accordance with all local
codes and ordinances.
Do not modify the plug provided. If it will notfit the
outlet, have the proper outlet installed by a qualified
electrician. Improper connection of the equipment-
grounding conductor can result in a risk of electric
shock. The conductor with insulation having an outer
surface that is green with or withoutyello w stripes is
the equipment-grounding conductor. If repair or
replacement of the electric cord or plug is necessary,
do not connect the equipment-grounding conductor to
a live terminal.
Check with a qualified electrician or service personnel
if the grounding instructions are not completely
understood, or if in doubt as towhether the tool is
properly grounded.
Repair or replace a damaged or worn cord immedi-
ately.
This tool is intended for use on a circuit that has an
outlet like the one shown in Figure 1. It also has a
grounding pin like the one shown. 1
PIN COVEROFGROUNDED
OUTLETBOX Fig. 1
CRIIFTSMIIWRADIALSAW315.220380 8