Green Light Power Switching | Crestron Commercial Lighting Design Guide |
The
The
Each control circuit is rated for 20A, supporting 120V, 277V, and 347V lighting loads, as well as motors up to 2 HP. Panels may be deployed with a mix of different voltages within a single cabinet.
The
As part of a complete Green Light system,
Remote emergency override mode allows the lighting system program to be overridden while each circuit is set to an override preset state. The override preset for each circuit is set using the local relay controls. Remote override mode is activated by an external contact closure from a Crestron
All
Crestron Green Light Express Power Switching panels are configured to order, and factory assembled and tested prior to shipping. Each panel is engineered to provide a clean and manageable installation with abundant provisions for wire termination and conduit knockouts.
MODEL NUMBERS
Specifying and ordering a Crestron Green Light Express Power Switching panel is facilitated using the following model number system. Simply fill in the appropriate entry in each position according to the steps that follow:
GLPS - HDSW - FT - 56
GLPS – Relay Type – Feed Type – Number of Ckts.
The above example is for a
Relay Type: Enter “HDSW” to specify modular
Note: For other relay types, refer to the Selection Guide
Feed Type: Enter “FT” to specify
Note: For other feed types, refer to the Selection Guide
Number of Circuits: Choose one of the following numeric values to specify the number of controlled circuits in the panel:
Small: 8, 16, 24
Large: 32, 40, 48, 56
Note: “Small” and “Large” refer to the default panel size per number of circuits. Consult Crestron Sales Support Services for alternate configurations.
“HDSW” relays must be ordered separately. Quantities shown indicate the number of available relay spaces. Each space accommodates one
Doc.4775A | 24 |