Crestron electronic GLPS-SW-FT DIN Rail Products, Crestron Commercial Lighting Design Guide, 2 in

Crestron Commercial Lighting Design Guide DIN Rail Products

Cresnet® Terminal Block for CAEN Automation Enclosures

The CAEN-BLOCK is a Cresnet terminal block designed specifically for Crestron lighting and automation systems to link remote enclosures to the central PAC2 or PAC2M control system. The CAEN-BLOCK mounts at the bottom of each CAEN enclosure that does not contain a control system to provide Cresnet and override signal connectivity for CLX-series lighting control modules. The CAEN-BLOCK serves as a parallel distribution block for multiple Cresnet cables, and especially provides for connection of the Cresnet and override signal cables from the central control system.

Crestron Network Block (CAEN-BLOCK) provides four termination ports for Cresnet wiring. The unit has two 5-pin connections that provide communication to the modules. Contact closure signals that produce an emergency override of the modules are also sent through these connections.

When a switch contact closure is received between the “G” connections and the “L” or “R” connection (R is used in a double-wide enclosure only) on the CAEN BLOCK, the respective left or right column of modules will set the lights to the programmed emergency override state.

The CAEN-BLOCK unit is a pass-through device with a Cresnet power factor of zero.

Network Block Dimensions and Weight

Height

Width

Depth

Weight

2 in

6 in

1 ¾ in

3.4 oz

NOTES: A module terminal block (CLT-series device) must be ordered for each module. The corresponding CLT terminal block is installed in the enclosure for high voltage wire termination. Each terminal block includes a terminal rail for mounting the block in the enclosure. Terminal rails and blocks do not occupy a module space within an enclosure.

CAEN-series enclosures are required to install CLX-series lighting modules.

Doc. Doc 4775A 46